Reference and clear data synchronization task configurations

Updated at:

This topic describes how to reference and clear the configurations of existing data synchronization tasks.

Reference a task configuration

Important

For data synchronization tasks in the Unconfigured state, you can perform the Reference Configuration operation.

  1. Log on to the OceanBase console or the .

  2. In the left navigation pane, click Data Transmission Service > Data Synchronization.

  3. On the Data Synchronization page, click Reference Configuration for the target task that you want to configure.

    image.png

  4. In the Reference Configuration dialog box, select the task to reference from the Select Existing Task drop-down list.

    image.png

    Note

    When you select a task, its configuration is cloned to the current task.

  5. Click OK and follow the on-screen instructions to configure the data synchronization task.

    You can use the exact configuration from the referenced task or modify it as needed. For more information about the configuration, see the documentation for the specific data synchronization task type.

    After the cloned data synchronization task starts, it runs based on the selected synchronization type. For more information, see View synchronization details.

Clear a task configuration

Important

You can use the Clear Configuration operation only for data synchronization tasks with a Subscription billing method and a status of Not Started, Completed, or Finished.

  1. Log on to the OceanBase console.

  2. In the navigation pane on the left, click Data Transmission Service > Data Synchronization.

  3. On the Data Synchronization page, click ... > Clear Configuration for the target task.

    image.png

  4. After you confirm the information is correct, click OK in the dialog box.

    image.png