Safety precautions

To ensure personal safety and the safety of the device, follow the included installation guide during installation, operation, and maintenance.

Before you touch any conductive surface or wiring terminal, use a voltmeter to measure the voltage at the contact point. Confirm that there is no risk of electric shock.

After you install the edge all-in-one machine, remove all packaging materials from the area, such as cardboard boxes, foam, plastic, and cable ties.

Only personnel who understand all safety precautions and correct procedures may install, operate, and maintain the edge all-in-one machine.

To prevent accidents such as scratches, bumps, and electric shock, wear the protective equipment and use the insulated tools shown below during installation, operation, and maintenance.

Use the edge all-in-one machine in an environment that meets the installation environment requirements. Otherwise, the device may malfunction. The quality assurance does not cover device malfunction, component damage, personal injury, or property loss that results from an improper environment.

Install the edge all-in-one machine indoors. Ensure the indoor environment meets the following conditions:

• It is free of water leaks or seepage.

• It is well-ventilated.

• The floor, desktop, or other platform for the machine is stable and well-grounded.

• It is free from pests, such as insects and rodents.

Leave at least 15 cm of space at the front and rear of the machine to allow for heat dissipation.

During installation, do not block the front and rear air vents of the machine.

Install the machine in a rack that is sturdy and undamaged.